Sofa - Airstream Basecamp 2007 Owner's Manual

Sofa

The pair of sofas can be used as seating or converted into a bed. They can be stored
out of the way or removed completely to make room for more cargo. The diagram
below shows one sofa in the seating position and one in the sleeping position.
Cushion A adheres to the wall by way of a magnet.
Cushions B and D form the bed cushions and filler cushions for the sofa.
Cushion E is not used for the bed cushions but as a filler in the sofa seat.
Item F is a shoulder bolt used to fasten the sofa assembly to the wall hinge.
Item G is the fold up sofa leg.
To make the sofa into a bed, pull out the bed slides (C) on both sofas and adjust the
cushions as shown.
The sofa assemblies may be removed from the trailer by removing the shoulder bolt
(F) on each hinge.
WARNING:
Sofa leg must be extended completely and locked into
place before using sofa as bed or seat.
SEAT
A.
B.
E.
D.
C.
G.
Sofa Storage
The diagram below shows the sofa in the storage position. The sofa assembly is hinged
and folds neatly against the wall for storage.
Item A is the fold up sofa leg.
Item B is a seat belt type strap used to gather the cushions into one convenient bundle.
Item C is a tether cord used to fasten the sofa assembly to the wall.
Item D is the travel rod. It must be installed during travel if the sofas are in the storage
position.
CAUTION:
with the sofas in the stored position. The tether strap (C) is for convenience only
and never should be used as the sole means of keeping the sofas in the storage
position during travel. Failure to use the travel rod may cause tether strap failure
and allow the sofas to fall during travel causing damage to the trailer and/or
cargo.
To store the sofas:
1. Strap the cushions (B) together.
2. Lift the sofa assembly to the wall and fasten the tether strap (C) to the wall eyelet.
3. Fold down the sofa leg (A).
4. Install the travel rod (D).
BED
F.
D.
B.
E - 10
The travel rod (D) must be installed whenever the trailer is moved
B.
D.
A.
INTERIOR
E
C.