Airstream Basecamp 2007 Owner's Manual page 61

Table of Contents

Advertisement

2. Remove the smoke alarm from the mounting bracket by twisting counterclockwise
3. Replace old battery with a fresh one. If your smoke alarm has a safety light, the
miniature lamp operates on two AA batteries. (See recommended batteries below.)
4. Check that battery connections are secure and the battery is secured in its
compartment
5. Test smoke alarm for proper operation (see "WEEKLY TESTING OF YOUR SMOKE
ALARM" section). The smoke alarm operates on a 9-volt battery. The normal battery
operating life will be one (1) year. The life of some batteries may be less.
6. Firex smoke alarms sold with Ultralife long-life lithium batteries require replacement
approximately every ten (10) years or when the low battery signal sounds.
CAUTION
: You should only use the batteries specified here or on the label of
the unit.
For Models A, B, C, E and PB use: Eveready 216, 522 or 1222; Mallory MN1604;
Duracell MN1604; or Ultralife U9VL-J.
For Model E also use AA Heavy Duty for light power. The miniature lamp operates
on two (2) AA batteries. For replacement, use heavy-duty or alkaline AA batteries:
Eveready 1215, E91, or Duracell M15HD, MN1500.
CAUTION
: Do not use any type of rechargeable batteries.
USING THE TAMPER RESIST LOCKING MECHANISM
To make the smoke alarm somewhat tamper resistant, a "locking pin" has been provided
in the base of the unit. It will help deter a child or other individual from removing the
smoke alarm from the bracket. See Figure 7. The following directions can install this.
1. Remove the breakaway locking pin from the unit by rocking pin back and forth.
2. Put the smoke alarm back on the mounting bracket. (See section "HOW TO INSTALL
YOUR SMOKE ALARM.")
3. Using long-nose pliers grab the head of the locking pin and insert into hole located
on the side of the smoke alarm. See Figure 8.
4. The Tamper Resist feature is now installed and complete.
To Remove:
5. Using long-nose pliers grasp the head of the locking pin and pull the pin completely
out of the smoke alarm.
6. The smoke alarm can now be removed from the mounting bracket with a counter-
clockwise twist.
E - 4
INTERIOR
E

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents