Playback Operations Using Thumbnails; Chase Play - Sony XDS-PD1000 Operation Manual

Note
Video and audio become discontinuous if you conduct
shuttle playback of a clip that does not have proxy AV
data.
To alternate between normal-speed playback and
shuttle mode playback
Set the shuttle/jog dial to the position corresponding to the
desired shuttle playback speed, then switch between
normal-speed playback and shuttle playback by pressing
the PLAY and SHTL/JOG buttons alternately.
Playback in variable-speed mode
In variable-speed mode, you can control the speed of
playback in the range of –2 to +2 times normal speed.
To carry out playback in variable-speed mode, select a clip
(see page 51) or an EDL, and then proceed as follows.
1
Press the shuttle/jog dial to turn off the JOG indicator.
The shuttle/jog dial enters shuttle mode.
2
Press the VAR/JOG button, turning it on.
3
Turn the shuttle/jog dial to the desired angle
corresponding to the desired playback speed.
Playback in variable-speed mode starts.
4
To stop playback in variable-speed mode, return the
shuttle/jog dial to the center position, or press the
STOP button.
To alternate between normal-speed playback and
variable-speed mode playback
Set the shuttle/jog dial to the position corresponding to the
desired variable-speed playback speed, then switch
between normal-speed playback and variable-speed mode
playback by pressing the PLAY and VAR/JOG buttons
alternately.
JOG indicator: Unlit
Playback operations using
thumbnails
Playback operations that you can perform with thumbnails
include searching for clips, displaying clip information,
and locking and deleting clip. This allows you to check the
actual video as you work.
See "Clip Operations" (page 63) for more information
about thumbnail operations.

Chase play

While recording to internal storage, you can start playing
the recorded part of the clip from the start, without waiting
for the recording to finish (chase play).
To perform chase play, perform steps 1 to 3 of "Selecting
a clip or an EDL" (page 51), and then proceed as follows.
1
Do one of the following to select a clip that show the
recording icon z.
• Turn the PUSH SET knob.
• Press the arrow buttons.
2
Press the PLAY button.
To jump to the last frame that is playable at that
time
Press the NEXT button.
Note
The minimum time difference between chase play and
recording source material is about seven seconds. You can
fast forward during chase play to come closer to the newest
material as it is recorded, but you cannot come closer than
seven seconds.
53
Playback