Sony XDS-PD1000 Operation Manual page 80

Item number Item name
212 VIDEO REMOTE CONTROL
SELECT
a) Not displayed when the unit is in 23.98P mode.
Item number Item name
320 DIGITAL AUDIO PB PROCESS ON
EDIT POINT
Item number Item name
501 STILL TIMER
Item number Item name
601 VITC POSITION
a)
SEL-1
80
Setup Menu
Menu items in the 200s, relating to the remote control interface
a)
Menu items in the 300s, relating to editing operations
Settings
Specify the handling of audio at clip joints.
cut: Carry out a cut (possibly resulting in audio discontinuities at the edit
fade: Fade out and fade in.
Menu items in the 500s, relating to the disc drive
Settings
To protect the disc against shock and vibrations, and to lengthen the life
of the laser diodes, the unit automatically enters standby off mode
whenever a specified time elapses in a disc stop mode (stop mode or the
still picture mode of search mode).
This allows you to set the time after which the unit exits a disc stop mode
and enters standby off mode.
0.5 sec [0.5 s] to 8 min [8 m] to 30 min [30 m]: Can be set in the range
off: Do not put into standby off mode.
Menu items in the 600s, relating to the timecode, metadata, and UMID
Settings
In 59.94i/59.94P/ Select the line into which to insert VITC signals (SD output)
29.97P mode 12H to 16H to 20H: Any line from line 12 through line 20.
• You can insert VITC signals in two places. To insert in two places, set
• In 59.94i/59.94P/29.97P mode (J), output of wide picture information is
• In 59.94i/59.94P/29.97P mode (UC), output of wide picture information
In 50i/50P/25P Select the line into which to insert VITC signals (SD output)
mode 9H to 19H to 22H: Any line from line 9 through line 22.
You can insert VITC signals in two places. To insert in two places, set
both item 601 and item 602.
Settings
Select the method used to control the internal digital video processor
and to make related settings.
menu: Use the setup menu to change settings.
remote (down converter) [dc]: Control the down-converter from an
HKDV-900 or another device connected to the VIDEO CONTROL
connector.
remote (up converter) [uc]: Control the up-converter from an HKDV-
900 or another device connected to the VIDEO CONTROL
connector.
point).
from 0.5 seconds to 30 minutes.
Notes
both item 601 and item 602.
given priority if OUTPUT in setup menu item 731 is set to "auto" and the
VITC insertion line is set to line 16.
is given priority if OUTPUT in setup menu item 731 is set to "auto" and
the VITC insertion line is set to line 20.
Note