Inserting/Removing An Sxs Memory Card - Sony XDS-PD1000 Operation Manual

Note
Recording to SxS memory cards (including copying),
playback, clip deletion, formatting, and other operations
are not supported.
Notes on the use of SxS memory cards
• Recorded data may be lost or corrupted in the following
cases.
- When this unit is subjected to shock or vibrations
during reading or writing of an SxS memory card, and
when this unit is powered off or an SxS memory card
is removed during reading or writing
- When this unit is used in an environment subject to
static electricity or electric noise
• Do not use or store SxS memory cards in locations that
are:
- outside the specified environmental ranges
- very hot, such in as vehicles parked in the sun during
summer, or exposed to direct sunlight, or near heaters
- subject to high humidity and corrosion
• When inserting a memory card, insert with the label side
facing the correct direction.
• Carry and store SxS memory cards in their cases, and
lock the cases securely.
• Guard against accidents and inadvertent data loss by
backing up the data stored on SxS memory cards. Sony
cannot be responsible for any consequences of damage
to or loss of data stored on SxS memory cards.
• Do not attach anything other than the supplied labels in
the designated label space. When attaching a label, make
sure it does not protrude beyond the label space.
Label space
• Clip operations may not be possible when the remaining
capacity of the media is low. In this case, use a computer
to delete unneeded files and try again.
• Open the memory card case completely before storing a
card in the case or removing a card from the case.
46
Handling SxS Memory Cards
To prevent accidental erasure
You can prevent accidental recording, editing, and
deletion of data on an SxS memory card by setting the
write protect switch to the WP side.
Note
Do not touch the write protect switch while an SxS
memory card is loaded in a memory card slot. Eject the
card before setting the write protect switch.
Inserting/removing an SxS memory
card
MEMORY ACCESS A/B lamps
MEMORY button
To insert an SxS memory card
Insert the SxS memory card into the card slot.
Insert with
the label
side facing
upward
The lamp lights in red then changes to green once the
memory card is ready for use.
Write protect switch
Memory card slots
Eject buttons