Remote Control Description; Battery Installation And Removal; Tabletop Remote Control - Krell Industries KPS 25sc Instructions For Use Manual

Playback system
Table of Contents

Advertisement

Remote Control Description
See Figure 5 on page 17
The KPS 25sc is equipped with two remote
controls. The tabletop remote control provides
complete compact disc transport functions as
well as Krell preamplifier and power amplifier
remote control functions.
The handheld remote control contains power
on/off, pause, play, stop, volume level control,
and track back and track forward keys.
BATTERY INSTALLATION
AND REMOVAL
The KPS 25sc Tabletop Remote Control uses
four AAA-size 1.5 Volt batteries. The KPS 25sc
Handheld Remote Control uses two AAA-size
1.5 Volt batteries. Batteries are included with
the shipment.
These directions apply to both the Tabletop
Remote Control and the Handheld Remote
Control.
1. Remove the backplate, using the supplied
T-10 Torx wrench.
2. Install the batteries, following the battery
position diagram on the plastic
battery
receptacle.
3. Replace the backplate.
The remote control is ready for operation.
Replace batteries when remote control function
becomes intermittent.
Remove batteries if the remote control is not
used for a long period of time. Battery leakage
can damage the remote control.
TABLETOP REMOTE CONTROL
The KPS 25sc tabletop remote control,
with
direct access capability, provides full-function
remote control operation. Tabletop remote con-
trol keys are labeled by section rather than
numbered individually. Cross references to front
panel buttons are in parentheses.
Direct Track Access Keypad
Use the direct track access keypad to select a
compact disc track. With the direct number
access function, the selected track begins play
immediately after you select it. If the track you
want to play is numbered 1-9, press the key
that corresponds to the track. Use the +10 key
to access tracks numbered 10 or higner.
Example: To access track 8, press the number
8 key once. To access track 10, press the +10
key once and the 0 key once. To access track
24, press the +10 key twice and the 4 key once.
Tracks consisting of two digits must be keyed
within eight seconds of each other.
Clear
Use this key to delete the last entry selected in
a programmed sequence.
Special Play Functions
Repeat Key
Press this key once to repeat the entire disc or
track program continuously. REPEAT ALL appears
in the compact disc display (1). Press twice
repeat the current track continuously. REPEAT 1
appears in the compact disc display. Press a
third time to cancel this function.
18
Krell KPS 25sc

Advertisement

Table of Contents
loading

Table of Contents