Table of Contents
Advertisement
Back Panel,
continued
See Figure 4 on page 14
Digital Inputs and Outputs
43 Optics1 and Optics2 Outputs
The KPS 25sc is equipped with two EIAJ fiber
optic digital outputs with TosLink connectors.
44 Coax1 and Coax2 Outputs
The KPS 25sc is equipped with two S/PDIF
coaxial digital outputs with RCA connectors.
45 AES Output and Input
The KPS 25sc is equipped with one AES digital
output and input with XLR connectors.
46 Optics1 and Optics2 Inputs
The KPS 25sc is equipped with two EIAJ fiber
optic digital inputs with TosLink connectors.
47 Coax1 and Coax2 Inputs
The KPS 25sc is equipped with two S/PDIF
coaxial digital inputs with RCA connectors.
Power
48 Back Panel Power Switch
Use the back panel power switch for the initial
KPS 25sc power on. For more information, see
Connecting the KPS 25sc to Your System,
on page 22.
49 Line Fuse
The 50/60 Hz line fuse protects the KPS 25sc
against short circuits from the external AC power.
Note
Replace fuses only with the fuse value speci-
fied on the back panel
50 IEC Connector
The connector is for use with the provided IEC
standard 15 amp AC power cord.
Back Panel Remote Connections
51 Krell Link Out
52 Krell Link In
The KPS 25sc is equipped with a Krell Link
communications output and input data port.
Krell Link allows synchronized remote power
on and off of other components with Krell Link,
such as Full Power Balanced amplifiers
or
Master Reference Am plifiers.
53 RC-5
The KPS 25sc is equipped with an RC-5 input
that makes custom installation
easy and secure
by accepting baseband RC-5 input commands
from hardwired remote controllers.
54 12 VDC Out
The KPS 25sc is equipped with an output that
sends 12 VDC power on/off (12 V trigger) sig-
nals to other Krel components and other
devices that incorporate a 12 V trigger. This
allows you to turn other components on or off,
or to and from stand-by, from the KPS 25sc.
When the KPS 25sc is switched between the
stand-by and operational modes, it sends a
signal from the 12 VDC Out that will switch
other components, allowing whole or parts of
systems to be easily coordinated.
Notes
The 12 VDC output power is limited to 30 ma.
Consult the owner's reference of the components
used in a custom installation to take full advan-
tage of the remote capability of the KPS 25sc.
16
Krell KPS 25sc
Advertisement
Table of Contents
