Table of Contents
Advertisement
Installing the Acrylic Cover
See Figure 1 on page 7 and Figure 2 on page 8
The KPS 25sc is equipped with an acrylic cover
that protects the integrity of compact disc data.
The user can customize the cover's operation
and closing speed. See Customizing Configu-
rations, on page 27.
IMPORTANTmUSER PRECAUTION
Please read the following USER PRECAU-
TION before attempting to install the acrylic
cover.
The KPS 25sc acrylic cover is mechanically
damped to ensure smooth operation while clos-
ing. If you force the cover to close, you will dam-
age the cover and the damping assembly.
During operation, please do not force the cover
to close faster than the damping mechanism
allows.
ATTACHING THE ACRYLIC COVER
To attach the acrylic cover, follow the steps
described below and further illustrated in Figure
1 on page 7.
IMPORTANT
Attach the acrylic cover before connecting the
flex foil cable.
1. Carefully remove the acrylic cover from the
velvet pouch and place the cover on a soft
surface.
2. Locate the two push-pull pins (A) just above
the KPS 25sc back panel. These pins are
shipped in the fully closed position (see
detail A.1). Pull the pins out until they are
fully extended, as shown in detail A.2.
3. Locate the pins (B) at the base of the acrylic
cover and the notches (C) on top of the
KPS 25sc, above the push-pull pins (A).
4. With the acrylic cover perpendicular to the
KPS 25sc, align the acrylic cover pins (B)
with the notches (C) in the top of the
KPS 25sc.
5. Gently lower the acrylic cover into the
notches (C), positioning the acrylic cover
pins (B) in the notches (C) in the top of
KPS 25sc.
IMPORTANT
Make sure that the flex foil cable (D) attached
to the cover is not pinched or crimped as you
position and secure the acrylic cover.
6.
Push the push-pull pins (A) back in
secure the cover. See detail A.1 for correct
pin position.
IMPORTANT
The KPS 25sc is shipped from the factory with
the cover push-pull pins fully closed. Push-pull
pins are fully extended only during cover instal-
lation and must be closed when operating the
acrylic cover.
Do not try to close the acrylic cover at this time.
Connect the flex foil cable first.
You can customize the acrylic cover to be clear
or opaque, and to close at varying speeds. See
Adjusting the Cover Closing Speed, on page
10, and Customizing Configurations,
on
page 27.
Krell KPS 25sc
Advertisement
Table of Contents
