Final Check - New Buck Corporation 21 User Instruction Manual

1. Recheck specified clearances.
2. Remove all foreign material from firebox area.
3. Open primary air draft.
4. Plug power cord into a 115V AC outlet when using with optional motor. "Do not run cord
under unit or in high traffic areas".
5. Place crumpled pieces of newspaper in the stove. Light it and close the door. Ensure
that stove draws properly through primary draft.
6. Check for smoke leaks around the door.
Open the door and check for smoke escaping from the front of stove. Smoking usually
indicates a defective or poorly positioned chimney. Some chimneys with a marginal draft
can be preheated by lighting newspaper and holding it near open damper with a poker or
fire tong. Once the chimney heats up, a proper draft can usually be obtained.
If a thorough review of the Troubleshooting Guide in the rear of manual does not reveal
problem, contact your dealer for assistance.
The unit is painted with a specially formulated high temperature paint that cures during
the first two or three firings. You may notice a slight smoking effect and an odor of
burning paint when you build the first fires. This is normal and is not a cause for
alarm. In some cases, these fumes will activate a smoke alarm. Opening a window near
the unit will allow these fumes to escape. DO NOT build a large, roaring fire until this
curing is complete or heater finish may be damaged.

FINAL CHECK

CAUTION
CAUTION
Page 28