Table of Contents
Advertisement
A. Chimney should be inspected twice a year.
B. The chimney should be cleaned as necessary to remove creosote, soot, leaves, birds' nests, etc.
!
NOTE: A chimney cap should be installed to prevent moisture from entering chimney, to prevent sparks and
burning materials from escaping chimney and to keep birds and foreign materials from entering.
*
NOTE: Some areas may require an approved spark arrestor
Before sweeping the chimney a few steps must be done. Put drop cloth down.
1. Open feed door and remove the Front Secondary Air Tube by removing cotter pin up in right side facing
stove. Remove Air Tube and cotter pin, set aside.
2. Remove the two Baffle Board's and set aside.
3. Close feed door for cleaning chimney so debris don't fall out feed door while cleaning chimney.
4. Creosote and debris will fall into the bottom of the stove unit from the cleaning.
5. Clean out all the creosote and debris from inside stove unit, if any is left from clean sweeping
chimney.
6. Replace Baffle Board's and Front Secondary Air Tube reverse steps 1-3
INSULATION BOARD BOTTOM POBPFB01
FRONT SECONDARY AIR TUBE PS210026
MIDDLE SECONDARY AIR TUBE PS210030
A. The heater should not be cleaned with any type of detergent as most all detergents have an oil base and
cannot be painted over.
B. The heater should be lightly sanded with fine sandpaper or steel wool, then repainted or touched up with
high temperature paint.
C. If the heater is located in a moist or damp location, check thoroughly for signs of condensation during
times when heater is not in use.
D. When heating season is over, heater should be cleaned out completely with a wire brush or cloth to help
eliminate ash and burned wood smell.
The glass door on your heater permits you to enjoy the beauty of the fire while retaining efficiency of your
heater. Although brand of glass used in heater door has well established and recognized heat resistant and
strength characteristics, it can be broken through improper care. To achieve maximum utility and safety of your
glass door, we advise that you observe following use and safety tips:
1. Inspect glass regularly for cracks or breaks. If you detect a crack or break extinguish fire immediately
and return door to your dealer for glass replacement before further use.
2. Do not slam heater door or otherwise impact glass. When closing door, make sure that no logs or other
objects protrude or impact against glass.
3. Do not clean glass with materials which may scratch it (such as steel wool) or otherwise damage glass.
Scratches on the glass can develop into cracks or breaks.
The glass can be cleaned with a commercial oven cleaner, providing it does not contain abrasives. A build-up
on glass that has been there for a considerable length of time can be burned off with a propane torch or straight
razor blade
Use protective gloves when using razor.
.
CHECK CHIMNEY
.
.
.
.
.
.
. .
. .
.
CLEANING THE HEATER
CARE OF GLASS DOOR
Page 46
.
INSULATION BOARD TOP POBPFB21
.
.
.
. .
.
REAR SECONDARY AIR TUBE PS210026
.
Advertisement
Table of Contents
