Front Under Cover; Muffler - DAELIM a.four Service Manual

EXTERNAL PARTS
FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT
3-6
CLIP CLIP CLIP
CLIP CLIP CLIP CLIP
CLIP CLIP CLIP CLIP
CLIP CLIP CLIP CLIP
CLIP CLIP CLIP
FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE BOLT FLANGE BOLT FLANGE BOLT
FLANGE NUT FLANGE NUT FLANGE NUT
FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT
FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT
FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT FLANGE NUT
FLANGE NUT

FRONT UNDER COVER

● Remove the front cover. ( 3-5)
● Remove the inner box. ( 3-5)
● Remove the front fender. ( 3-5)
● Remove the front wheel. (
● Loosen the flange bolts securing the lower end of the
inner box.
● Remove the front under cover.
● Install in the reverse order of removal.
•Pay attention not to turn over the vehicle.

MUFFLER

● Loosen the 3 flange nuts securing the EX pipe comp.
● Loosen the 2 flange bolts securing the R. crankcase.
● Loosen the 2 flange bolts securing the rear wheel mud
guard.
● Remove the EX muffler comp.
•Never perform the maintenance of the muffler right
after stopping the vehicle because the muffler is
extremely hot
EX. PIPE REMOVAL
● Loosen the 2 flange bolts securing the cylinder comp.
● Remove the EX pipe by drawing it to the ground
direction.
INSTALLATION
● Install the 2 flange bolts after securing the EX pipe
with the stud bolt of the cylinder comp.
● Install the gasket on the EX muffler, connect the EX
pipe and install the 2 flange nuts temporarily.
● Install the 2 flange bolts on the R. crankcase
temporarily.
● Tighten the 3 flange nuts to install the EX muffler and
the EX pipe.
● Install the 2 flange bolts on the rear wheel mud guard.
● Tighten the muffler securing 2 flange bolts to install the
R. crankcase.
● Tightening torque of the R. crankcase.
3.3kgf· · m
TORQUE :
•When installing the gasket, replace it with the new
one.
•Check to see if there is any evacuation after installing
the muffler.
10-5 )