Steering Head Bearing; Battery - DAELIM a.four Service Manual

INSPECTIONS/ADJUSTMENTS
BATTERY COVER
DIGTAL TESTER
2-10
TAPPING SCREW
● Check the tread depth at the tire center.
● If the tread depth has reached the service limit, replace
the tire.
SERVICE LIMIT : 4.0mm
7.5mm

STEERING HEAD BEARING

•Check the cable if it interferes with the handle
operation.
● Lift the front wheel and check if the handle moves right
and left smoothly. If the handles move heavily, check if
the cable or electric cord interferes with the handle. If
the hadle moves satisfactorily, adjust the steering head
bearing.

BATTERY

● Remove a tapping screw securing the battery cover
from the floor panel.
● Check if the terminal is loose.
● If the terminal is loose, check and clean the contacting
surface and then tighten it.
● Apply grease thinly after tightening.
● If the terminal is rusted, remove the battery, pour warm
water and clean with the wire brush.
- FULL CHARGING VOLTAGE : 13.0~13.2V
- LOW CHARGING VOLTAGE : LESS THAN 12.3V
•Check the charging condition using the voltmeter.
•Pay attention not to transform the battery terminal.
•Never remove the filler cap.