Heathkit H14 Manual page 16

_P._9._' 4
~
/
This setting will remain until power down or until it
is changed through one of the above software com-
mands. The '''Iidth of characters cannot be changed
within a line.
When you change the width by using a console ter-
minal escape code. type the code with no spaces.
Example: To type ESC u
crL-A:
press the escape key
(ESC), press the u key. and then push down the con·
trol (Cfl) and shift keys and strike an a.
ESC, lower case x - (Selline spacing to 6 lines per
inch) This is the normal line spacing, which will
be activated upon power up. Use this code to
return to this normal spacing after modifying
the spacing to 8 lines per inch by a previous
software command.
ESC. lower case y - (Set Iinc. spacing 10 8 Ii
Des
per
inch) This code. when received, will cause the
printed lines to be spaced to 8 lines per inch.
Print Conlrols
(for proper operation, shaded commands should not
be sent to the Printer except as part of the ESC-u
sequence as described above.)
NarE: When you operate your Printer. the paper
drive motor may appear to become excessively warm.
This condition is normal.
c
o
c