Heathkit H14 Manual page 14

,
Page 12
--------------~
PLATEN
RI880N
PRINT
HEAD
•
RIBBON
ROLLER
'/
RIVET MUST
BE HERE
_-\!t--"";':;;I
~
ON
SPOOL
SPOOL DRIVE SHAFTS
RIBBON
ROLLER
\
~
PICTORIAL 5
PAGE LENGTH
When power is turned on, the Printer sets the fonn
depth to 11 inches. To modify the form depth:
1. Press the ON LINE switch to the OUT ("off
line") position.
2. Press in and hold the TOP FORM switch.
3. Use the FEED FWD switch and advance the
form to the desired length.
4. Release the TOP FORM switch.
5. Press the ON LINE switch to the IN position.
The form depth has now been reset.
RIBBON INSTALLATION
To install a ribbon:
1. Turn off the Printer.
2. Refer to Pictorial 5 and manually move the
print head to the approximate center of the
platen.
3. Remove the old ribbon by lifting the two
spools from the two spool drive shafts and
pulling the ribbons from the mechanism.
4. Place a new ribbon on the spool drive shafts
and thread
it
as shown.
•
•