Heathkit H14 Manual page 13

Page 11
~
......
_------------
MINIMIZE THIS
DISTANCE FOR
MOST RELIABLE
PAPER FEEDING
PAPER BASKET
t
TOP COVER
PA PER
PA PER
HOLDDOWN
RIBBON~
@
FEED
~
SPROCKET
PLATEN GUIDE
•
PICTORIAL 4
POWER LINE CONSIDERATIONS LOADING PAPER
•
If you change the position of the rear panel 120/240
switch, be sure you change fuse F1 to the proper value
as follows:
For 120 VAG, use a 1-ampere, 125-volt, slow-
blow fuse.
For 240 VAG, use a l/2-ampere, 250-volt, slow-
blow fuse.
Feed the paper between the paper basket and the
chassis. You can then use the basket to collect the
printed paper. Be sure there are no sharp corners for
paper to catch on, and do not allow a large amount of
printed paper to pile up on the paper supply.
To load paper, refer to Pictorial 4 and:
1.
Lift
the top cover.
Be sure the
NORILOW
switch is set in its proper
position to match your line voltage as follows:
2. Open the paper hold-downs by lifting them
away from the center of the paper.
NOR range-ll5 Vto 135 Vrms or230 Vt0270
V rms.
LOW range -100 V to 120 Vrms or 200 V to 240
V rms.
3. Place the paper as shown and feed it
through the opening at the rear of the top
cover, under the paper guide, and between
the ribbon and platen. NOTE: Using
multiple-copy forms is not recommended.
NOTE: If you do not know the value of the line voltage
in your area, sefthe NORILOW switch to NOR.
4. Place the sprocket holes of the paper onto
the
left~hand
sprocket and close the paper
hold-downs.
Inside your Printer, set section two of circuit board
switch SW102 as follows:
•
LINE FREQUENCY
60 Hz
50 Hz
SET SWITCH TO
1
~
5. If necessary, adjust the sprocket spacing on
the drive shaft by loosening the knurled
thumbscrew and sliding the right sprocket
and paper hold-down assembly sideways
on the shaft to a position which matches the
sprocket holes in the paper. Then retighten
the thumbscrew. Close the right paper
hold-down.