2 - 32 MC67 Integrator Guide
Handstrap Replacement
Removal
To remove a handstrap from the MC67:
CAUTION
If the MC67 is in suspend mode, press the red Power button to wake the MC67.
1.
Press the red Power button. The Power Action Key window appears.
2.
Tap Safe Battery Swap. The Data Capture LED lights red.
3.
When the LED turns off, remove the handstrap.
4.
Handstrap Clip Removal
Figure 2-35
Remove the battery.
5.
CAUTION
Using a small flat screwdriver, push the head of the screwdriver between the handstrap pin and the bottom
6.
of the housing as shown below.
Pry the handstrap and pin up and out of the handstrap mount area.
7.
Close all running applications prior to replacing the handstrap. The backup battery maintains data for
up to 15 minutes. If replacement takes longer than 15 minutes data may be lost.
When removing handstrap pin, be careful not to damage handstrap mounting area.