Table of Contents
Advertisement
Battery Replacement
When the battery's capacity is critically low, the HC700-G
automatically enters "Critical Low Battery" state and shuts
down all functions (the screen turns off) to preserve the data
in its memory. The HC700-G allows you to replace batteries
without losing information stored in its memory. To avoid los-
ing data stored in the memory, a charged battery must be
installed within 30 minutes.
To replace a battery perform the following steps:
1. Make sure that the HC700-G is powered off (See "Turn-
ing Off" on page 11.).
2. Remove the HC700-G hand-strap (see Figure 4).
3. Press the battery snap on the battery (see Figure 4) and
pull away the battery from the HC700-G.
4. Insert a fresh battery, bottom end first, into the battery
compartment.
5. Carefully, press the battery top downward until it clicks
and locks in place.
6. Press the Power Button - the HC700-G is now ready for
use.
Battery Compartment
8
Hand-strap
Figure 4. Battery Installation and Removal
Battery Snap
Advertisement
Table of Contents
