Table of Contents
Advertisement
Network Printing in a Windows Environment (Available only with FAX3900)
6.4.3
Printing to Port 9100
Windows 2000/ Windows XP
Important
Before continuing to set up the network settings, check the following:
Check that the computer is set up to use the TCP/IP protocol.
Check that the copier is also set up to use the TCP/IP protocol.
Check that the printer driver has been installed on the computer.
(For details on installing the printer driver, refer to "Installing the Printer
Driver" on page 3-1.)
1
When using Windows 2000, click [Start], point to [Settings], and then
click [Printers] to open the "Printers" folder.
When using Windows XP, click [Start], point to [Control Panel], then
[Printers and Other Hardware] , and then click [See a list of installed
printers and fax printers.]
2
Right-click the icon for the installed printer driver.
3
Click [Properties] to open the Properties dialog box.
4
Click the "Ports" tab, and then click [Add Port].
5
In the Printer Ports dialog box, select
click [New Port].
6
When the Add Standard TCP/IP Printer Port Wizard appears, click
[Next>].
7
Enter the IP address for the copier into the
Address
8
Select Custom, and then click [Settings].
9
Select
10
Enter "9100" for the
11
Click [Next>].
box, and then click [Next>].
RAW
as the protocol.
Port Number
Standard TCP/IP
Printer Name or IP
setting, and then click [OK].
6
Port, and then
6-15
Advertisement
Table of Contents
