Putting Into Service; Checking The Contents Of The Package; Important - Siemens Gigaset M 101 Data Operating Instructions Manual

Putting into service

Putting into service

Checking the contents of the package

Important

8
Follow the step-by-step instructions described below for putting
the equipment into service:
1. Check the contents of the package
2. Install the configuration program
3. Connect the station
4. Conclude commissioning by performing an initial configura-
tion, see "Initial configuration" on page 11.
The package contains:
Gigaset M101 Data
Plug-type AC adapter C39280-Z4-C59/
C39280-Z4-C168 for mains connection
Serial 9-pin connection cable for connecting
the V.24/RS232 interface
CD-ROM with the installation program
Operating instructions
Before you put the Gigaset M101 Data into service, the
peripheral device that you want to operate as a cordless
unit (modem, PABX) must be configured at the COM
port on the PC side since it is to be used for transferring
data. For information on configuration, see the appropri-
ate documentation on the peripheral device and your
computer's operating system. This configuration is par-
ticularly necessary for plug&play installations, as other-
wise errors can occur depending on the installation rou-
tine of the connected peripheral unit.
If you want to operate a modem, for example, via the ra-
dio link, first connect the modem directly to the PC, con-
figure it, set up a test connection, and then install the ra-
dio link. To do this, disconnect the modem from the PC,
connect the Gigaset M101 Data and perform the config-
uration.
When choosing a location for the devices, read the
"Notes on installation and operation" on page 20.
M101 Twin
Data Pack
1 2
1 2
1 2
1 1
1 1