Start Up; Operation; Cleaning; Weekly Exterior Care - Follett T400A Installation, Operation And Service Manual

Ice transport tube installation detail
1
2
Heat end of transport tube in cup of 160 F
(71 C) hot water to soften (1) and spread
with pliers before making connection (2).
RIDE model ice machine start up procedure
The start-up procedure below is intended to ensure that ice machine is operating properly after installation has
been made. Check each item listed and call factory immediately for assistance if you experience problems with
unit.
Before turning on power
1. Turn on water to ice machine.
2. Push down on fl oat to force water through overfl ow chamber into evaporator drain pan and check for proper
drainage of drain pan.
3. Check that fl oat valve shuts off incoming water when raised.
4. Check that hose clamp securely holds ice transport tube on evaporator port.
After turning on power
1. Turn on power to ice machine and confi rm that gearmotor, fan motor and compressor start immediately.
2. Check that ice begins to enter dispenser bin area within approximately 10 minutes.
3. Check that fl oat reservoir water level is approximately 3/8" (.95mm) below overfl ow during ice machine
operation and adjust to this level if necessary.
4. Put ice against bin level thermostat in dispenser bin and check that compressor and fan motor shut down
approximately 10 seconds after thermostat opens. Gearmotor should run for an additional 60 seconds.
5. Check that ice machine comes back on in approximately 20 minutes (bin signal must be present).

Operation

Cleaning and preventive maintenance (all models)
Preventive maintenance
Periodic cleaning of Follett's ice machine system is required to ensure peak performance and delivery of clean,
sanitary ice. The recommended cleaning procedures that follow should be performed at least as frequently as
recommended and more often if environmental conditions dictate.
Cleaning of the condenser can usually be performed by facility personnel. Cleaning of the ice machine system,
in most cases, should be performed by your facility's maintenance staff or a Follett authorized service agent.
Regardless of who performs the cleaning, it is the operator's responsibility to see that this cleaning is performed
according to the schedule below. Service problems resulting from lack of preventive maintenance will not be
covered under the Follett warranty.

Weekly exterior care

The exterior may be cleaned with a stainless cleaner such as 3M* Stainless Steel Cleaner & Polish or equivalent.
* 3M is a trademark of 3M Company.
install insulation on full run of tube
Evaporator
install clamp behind lip on
evaporator port
17
Dispenser
grommet