Turning On The Power; Initial Unit Setup; Quick Setup Screen - Eneo DLR2-04N/80 Operating Instructions Manual

Table of Contents

3.2 Turning on the Power

Connecting the power cord to the DVR turns on the unit. The unit will take approximately 60 seconds to initialize.

3.3 Initial Unit Setup

Before using your DVR for the first time, you will want to establish the initial settings. This includes items such as time and date, display language, camera,

audio, remote control, record mode, network and password. Your DVR can be set up using various screens and dialog boxes.

Press the MENU button to enter the setup screens. The Admin Password screen appears.

Enter the password by pressing the appropriate combination of camera number buttons and then the

There are two Setup screens: Quick Setup and Normal Setup. The factory default is the Quick Setup screen

3.4 Quick Setup Screen

The Quick Setup screen allows you to set up the most commonly used features of your DVR. Use the arrow buttons to move through the options. Pressing the

button lets you make your selections.

Highlight the box beside Quick Setup and press the

change the DVR's settings.

Highlight the first box beside Recording Speed/Quality, and select recording speeds from as few as 0.5ips to as fast as 30ips (25ips for PAL).

NOTE: The DVR has a maximum recording speed of 30ips per camera; however, the recording speed may not be achieved when averaged over all

cameras.

Highlight the second box beside Recording Speed/Quality, and select from Very High, High, Standard and Low.

Highlight the box beside Audio Recording and select either On or Off.

NOTE: It is the user's responsibility to determine if local laws and regulations permit recording audio.

Highlight the box beside Sequence Dwell Time and select from 3 to 60 seconds for the camera sequence dwell time.

Selecting System Information enters a screen where you can set up system information.

Selecting Storage Check enters a screen where you can check the storage status.