Elation Design Spot LED Manual page 25

fixture channel and test it's function independently from the control board.
7.5.2 Manual Control –This function will center the pan and tilt motors and at the
same time bring the dimmer to 100%. The pan and tilt function will still operate if
the fixture needs to be positioned to a flat clear surface.
7.5.3 Calibrate values – This function should only be performed by a technician
qualified to do so. This function allows a user to make small adjustments to the
effect wheels (color, gobo, shutter, etc) to compensate for ware or in the event a
sensor has been knocked slightly out of place. Because improper use of this
function can result in undesired operation this function has been password
protected. The password is 050 and must be entered each time the calibration
menu function is entered. Because calibration is an extremely delicate procedure
instruction on performing this action are left out of this manual. For a first time
calibrator, please contact our customer support team for step by step
instructions.
7.6 User Mode Set:
7.6.1 User mode – This function allows the user to create user defined channel orders
allowing the fixture to match the channel order of other fixtures on the market for
easier operation. A total of three user modes may be configured: User Mode A,
User Mode B, and User Mode C.
7.6.2 Edit User mode – This function allows the user to make the actual changes in
the user-defined modes that are created in the previous function.
7.7 EDIT PROGRAM: - The fixture comes equipped with a built-in DMX recorder that allows
custom programs to be installed and recalled directly from the fixture's control board.
Programs can be created and stored using the fixture's control board or by using an
external DMX controller. For detailed instructions on how to complete this task please
see Section 10/ Page 33.
7.7.1 Select program – This function allows the user to select one of ten of the user
©Elation Professional® 25
Design Spot LED™
Design Spot LED™