JVC KW-V41BT Instruction Manual page 50

CONNECTION/INSTALLATION
Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
Make the proper input and output wire
2
connections for each unit.
Connect the speaker wires of the wiring
3
harness.
Connect the wiring harness wires in the
4
following order: ground, battery, ignition.
Connect the wiring harness connector to
5
the unit.
Install the unit in your car.
6
Reconnect the
·
7
battery.
Press the reset button.
8
Configure <Initial Settings>. (Page 4)
9
50
Installing the unit
Installing the unit (only for KW-V41BT
·
Region 4/KW-V21BT Region 4/KW-V11
Region 4)
• Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
Installing the unit using the mounting
bracket removed from the car
5 or 6
• Select the appropriate type of screw for the
mounting bracket: flat head (5) or round head
(6).
Installing the trim plate (only for KW-
V41BT Region 4/KW-V21BT Region 4/
KW-V11 Region 4)
Attach the trim plate (
1
Car Bracket
5 or 6
2
).
2