Osd Attention Signal - Philips 220VW8FB/00 Service Manual

8 220VW8 LCD
Clock & Phase Adjustment
Due to the different quality of video signal generated from
graphics cards. It is necessary to adjust CLOCK and PHASE
functions for the optimal video display of LCD monitor. So
maybe some flicker appeared as Fig.1 & 2.
Fig.1
Following steps will guide you to make correct adjustment of
CLOCK and PHASE:
a. Restart your computer.
MENU
b. Press to bring up OSD menu after the OS
(Operation System) boot up.
< >
c. Press or to select the option of
then
MENU
press to bring up its submenu as shown in Fig.3.
Clock Phase
d. Select the or
< >
and press or to adjust.
(If the phenomenon as Fig.1, you should adjust "
(If the phenomenon as Fig.2, you should adjust "
MENU
e. Quit OSD by press
Fig.3
However, CLOCK and PHASE functions are only available
while analog video signal is supplied. Operating unit under
digital signal state, the video clock information can be
obtained from graphics cards directly. Therefor, it is
unnecessary to adjust these functions.

OSD Attention signal

The monitor will detect various display situation
automatically. When the monitor detects the problems, the
screen will show the different warning signals to remind you
what is happen to your monitor.
1. NO VIDEO INPUT
This screen appears if there is no video signal input. Please
check that the signal cable is properly connected to the video
card of PC and make sure PC is on.
OSD Attention Signals
Fig.2
More Settings
and
adjustment items in submenu
Phase
Clock
button to save the settings.
2. CANNOT DISPLAY THIS VIDEO MODE
This screen warns then the input frequency from the
computer is not a standard video mode or out of the monitor's
scanning range. Please change the display results.
CANNOT DISPLAY THIS VIDEO
MODE, CHANGE COMPUTER DISPLAY
3. ENTERING SLEEP MODE
This screen appears when the monitor is about to enter the
sleep mode. Please press any key on the keyboard or click
the mouse to wake up the monitor and computer.
")
")
4. WAIT FOR AUTOMATIC ADJUSTMENT
This screen appears when you touch the
disappear when the monitor is properly adjusted.
WAITING FOR AUTOMATIC ADJUSTMENT
5. USE 1680*1050 FOR BEST RESULT
This message appears at the top of the OSD window when
the video mode input is not the recommended 1680*1050.
Other modes may result in some picture distortion. Please
adjust the video mode to 1680*1050 at 60Hz for best display
quality.
USE 1680 X 1050 FOR BEST RESULT
6. SELECTED INPUT NOT AVAILABLE
When you select video input between analog or digital signal
via INPUT SELECTION function of OSD menu, if the one you
are selecting is not available, following message will appear
on the screen then switching back to the previous setting
automatically.
SELECTED INPUT NOT AVAILABLE
ATTENTION
NO VIDEO INPUT
ATTENTION
INPUT TO 1680X1050 @60HZ
ATTENTION
ENTERING SLEEPING MODE
AUTO
ATTENTION
ATTENTION
ATTENTION
button. It will