Ddc Instructions - Philips 220VW8FB/00 Service Manual

AUTO
7. Press icon of the toolbox and make sure all of the
setting are fixed, then press the
perform the loading process automatically.
8. When the loading process completed, and the dialog box
appeared the message of verify ok. Press the
to disconnect the linkage, LED of monitor will light up.
Electronic Instruction
RUN
icon. Program will
DIS-CON
icon

DDC instructions

General
DDC Data Re-programming
In case the DDC data memory IC or main EEPROM which
storage all factory settings were replaced due to a defect, the
serial numbers have to be re-programmed.
It is advised to re-soldered DDC IC and main EEPROM from
the old board onto the new board if circuit board have been
replaced, in this case the DDC data does not need to be re-
programmed.
* According to the design concept of this product, DDC data
will be divided into two parts to deposit in different place:
DDC data of VGA interface are saved in scaler IC.
Additional information
Additional information about DDC (Display Data Channel) may
be obtained from Video Electronics Standards Association
(VESA). Extended Display Identification Data(EDID)
information may be also obtained from VESA.
System and equipment requirements
1. An i486 (or above) personal computer or compatible.
2. Microsoft operation system Windows 98/2000/XP.
3. Installation software of " TVI Tool ".
4. Executive program " TVI Tool. exe ".
5. ISP tool kit, as shown in Fig1.
Including: a. Alignment fixture x 1
b. Printer cable (LPT type) x 1
c. D-sub to D-sub cable x 1
PC
Monitor(A)
Fig. 1
TVI-TOOL
Install and setup
Step 1: Create a folder in your PC, for example : D:\TVI-TOOL.
Step 2: Copy the installation file into the folder.
Step 3: Double click the INSTALL icon as shown in the Fig.2.
Step 4: Following the installation wizard, complete the whole
installing progress.
Step 5: Restart your PC to
(More details are shown in the next page)
220VW8 LCD
Monitor (B)
program
17