Table of Contents
Advertisement
Available languages
Available languages
Commissioning /Operation
Removal
j
Raise up the impact protection flap
j
Remove the grass box
Adjusting the cutting height
Q
c Danger!
J
Switch the appliance off! Wait until the curved
blade bar
comes to a complete stop!
21
j
The appliance permits 6 adjustments of
cutting height, from 20 to 70 mm (see Fig. D).
Tip!
j
For the first cut of the season, when the stems
have grown to at least 5 to 6 cm, set a high
cutting height. Subsequently, always mow with
the same cutting height adjustment, if possible.
Repeat this procedure weekly if possible, for as
long as the grass continues to grow - i.e. into
the autumn. Immediately before the winter peri-
od mow the grass for the last time down at the
usual cutting height.
j
Release the switch lever for cutting height
ad-justment
to the outside.
12
j
Lift or lower the lawn mower to the desired
cutting height, up or down.
j
Re-engage the switch lever for cutting height
adjustment
.
12
Connection to the power supply
Q
c Danger!
J
Connect the plug coupling of the extension
cable with the power socket
J
Secure the extension cable by hanging it in the
power cable strain relief fitting
12 GB/IE/CY
.
11
.
10
.
4
.
7
Operation
Q
Switching the appliance on / off
Q
j
Switch the appliance on only when the curved
blade bar o and the motor have come to a
complete stop!
j
Under no circumstances should you switch the
appliance on and off in quick successions!
Switching on
j
Press and hold the safety button
j
Then pull the handle switch
steering shaft handle
j
Hold the handle switch
the safety button
3
Switching off
j
Release the handle switch
The curved blade bar
ta-te after switching off! Avoid all physi-
cal contact with the sharp and fast-rotat-
ing curved blade bar
Operating the mower
Q
j
Mow only with forward movements and with a
steady and even walking tempo.
j
Start close to the wall power socket, at the
edge of the grassed area.
j
Mow from there with bordering cutting paths
and in alternating directions.
c Overload protection
The overload protection prevents damage to the
appliance. It switches the motor off as soon as a
blockage is apparent or an overload threatens.
j
If the overload protection activates itself, allow the
appliance to remain switched off for ca. 5 minutes.
j
Remove the possible cause (e.g. long grass
straws or foreign bodies).
j
Increase the cutting height by about 2 cm
should the overload have been caused by long
grass straws.
.
3
towards the
5
.
1
firmly and release
5
.
.
5
continues to ro-
21
!
21
Advertisement
Chapters
Table of Contents
