Door Replacement And Adjustment; Troubleshooting - Viking Professional freestanding gas self-clean sealed burner ranges Use & Care Manual

Door Replacement and Adjustment

1
Reinstall door to range.
3
Remove pins from hole in hinges.
5
If the door needs to be adjusted, loosen
hinge trim screws located in step 2. Adjust
the screws located between the door
and kickplate using a 5/32" hex head
allen wrench. After adjustment,
tighten hinge trim screws.
52
2
Open door completely.
Reinstall hinge trim.
4
Close door.

Troubleshooting

Problem Possible Cause and/or Remedy
Range will not function. Range is not connected to electrical power:
Have electrician check power circuit breaker,
wiring, and fuses.
Oven does not operate in Door is not shut tight enough for automatic
self-clean. door latch to lock.
Oven is not clean after self- Temperature control knob not rotated all the
clean cycle. way past clean until it stops.
Broil does not work. Temperature control knob is rotated too far
past broil position.
Door will not open. Oven is still in self-clean mode. If oven is
hot, door latch will release when safe
temperature is reached.
Oven light will not work. Light bulb is burned out.
Range is not connected to power.
Igniters will not work. Circuit is tripped.
Fuse is blown.
Range is not connected to power.
Igniters sparking but no Gas supply valve is in "OFF" position.
flame ignition.
Gas supply is interrupted.
Igniters sparking Power supply is not grounded.
continuously after flame
ignition. Power supply polarity is reversed.
Igniters are wet or dirty.
Burner ignites but flame is Burner ports are clogged.
large, distorted, or yellow.
Unit is being operated on wrong type of gas.
Air shutters not properly adjusted.
Strong odor and/or smoke This is normal burn off of insulation and
is noticed first few times protective oils in oven. This will go away
oven is used. after using oven a few times.
Oven indicator light on; Oven is operating properly. Unit will resume
oven will not heat heating function once it has cooled.
53