Standoff Bracket Removal; Final Installation; Door Replacement And Adjustment - Viking Vgcc5366bss Installation Manual

Standoff Bracket Removal

DANGER
FIRE HAZARD
Backguards come standard with
standoff brackets which provide
a barrier between back of range
and rear wall. These must be in place for
adequate ventilation. The standoff brackets
may only be removed if range is installed
against a non-combustible wall.

Final Installation

1
Install island trim. Attach with four screws provided.
3
Burner caps are packed in styrofoam top pack with the grates.
Place burner on top of range. Place burner grate on top of burner
cap and grate support.
Note: Arrow on burner cap must be pointing towards back of range.
20
Note: Standoff brackets can only
be removed if range is installed
against a NON-COMBUSTIBLE
wall. Please see the backguard
install guide for instructions on
how to remove the standoff
brackets.
2
Slide range into place. Be sure
anti-tip bracket slides into the anti-tip opening.
4
" " "
3 / 8 3 / 8 3 / 8
) ) )
c m c m c m
9 5 9 5 9 5
( 0 . ( 0 . ( 0 .
Check that unit is level side to side
and front to back. The side trim must be 3/8" (0.95 cm)
above countertop. If unit is not level repeat steps 5-7
of "Leveling/Adjustments/Alignment" section.

Door Replacement and Adjustment

1
Reattach door to range.
3
Remove pins from hole in hinges.
5
If the door needs to be adjusted, loosen hinge trim screws located in
step 2. Adjust the screws located between the door and kickplate using a
5/32" hex head allen wrench. After adjustment, tighten hinge trim screws.
2
Open door completely. Reattach hinge trim.
4
Close door.
21