Replacing Oven Lights; Door Removal - Viking Professional freestanding gas self-clean sealed burner ranges Use & Care Manual

Replacing Oven Lights

WARNING
ELECTRICAL SHOCK HAZARD
Disconnect the electric power at the main fuse or circuit
breaker before replacing bulb.
WARNING
DO NOT touch bulb with bare hands. Clean off any signs of oil from
the bulb and handle with a soft cloth.
DANGER
DO NOT touch bulb with bare hands. Clean off any signs of oil from
the bulb and handle with a soft cloth.
1. Unsnap glass light cover
using a screwdriver in the
DANGER
access groove.
access
groove
2. Firmly grasp light bulb and
pull out.
CAUTION
3. Replace with halogen bulb
using volt and wattage
requirements listed on glass
cover.
4. Replace the light cover by
CAUTION
snapping glass cover onto
metal box.
5. Reconnect power at the main
fuse or circuit breaker.
FOR YOUR SAFETY
50
glass light
cover
light
bulb

Door Removal

WARNING
TO PREVENT
PERSONAL INJURY
Before removing the doors,
make sure the pins are
properly installed in the hinges.
Failure to do so can result in
personal injury to hands
and/or fingers.
2
Remove hinge trim screws
and hinge trim.
4
Lift door up and out.
51
1
Open door completely.
Place pin in pin hole.
3
Close until pins stop door.