Preparing For First Use; Attaching The Auxiliary Handle; Inserting A Tool Into The Chuck; Opening The Chuck And Inserting A Tool - Parkside PSBM 1100 Operation And Safety Notes

Preparing for first use

Attaching the auxiliary handle

For reasons of safety, this device must be used
only with the auxiliary handle
properly attached.
It is essential that you note the following:
if the drill becomes jammed, a very large torque
can be generated („the force that the machine will
exert to rotate about its own shaft").
j
Attach the auxiliary handle
collar and fix in place by tightening the wing
screw. Attach the depth stop
you to drill to the exact depth required.

Inserting a tool into the chuck

Caution! Before starting any tasks on the hammer
drill, make sure that it is switched off and the
mains plug is out of the socket.
The RÖHM quick-release drill chuck allows you to
exchange drills or other tools without using a
special key etc.
Opening the chuck and
inserting a tool
j
Hold the rear shell of the quick-release chuck
and turn the front shell until the tool (e.g. a
roundshanked drill) can be inserted. Insert
the tool.
Tightening the chuck on
to the tool
j
Hold the rear shell of the quick-release chuck
and turn the front shell sharply until you hear
a „click – clack, clack, clack" sound (refer to
Figure A). The chuck is now locked. To release
the lock again, just turn the front shell in the
opposite direction.
in place and
8
8 to the spindle
10 . This will help
9
9
Preparing for first use / Operation

Using the tool as a driver

j
You will require a suitable bit holder if you wish
to use screwdriver bits with the drill.
The screwdriver bits used must be match the
screw head. Set the switch
symbol.

Operation

Figures B - H show the various possible applications
and uses.
Examples of applications and uses. Drill bits not
included.
The mains voltage at the mains socket must match
that shown on the rating plate on the device.
Devices marked with 230 V can also be operated
at 220 V.

Switching on and off

Switch on intermittent operation mode:
j
Press the On / Off switch
Switch off intermittent operation mode:
j
Release the On / Off switch
Switch on constant operation mode:
j
Press the On / Off switch
pressed, then press the locking button
Switch off constant operation mode:
j
Press the On / Off switch
Infinitely adjustable
speed setting
To produce a slow speed, just press lightly on the
On / Off switch . This allows you to start up your
3
operations smoothly and in a controlled manner.
If you increase the pressure on the On / Off switch
3 , the speed will also increase.
1 a to the drill
3
.
3
.
, and keep it
3
4
.
3 and release it.
GB/IE 9