Installation Instructions - Jenn-Air JGS8750ADB Service Manual

Installation Instructions

FIGURE 1
Notes:
1. Provide for either a 3-wire or 4-wire 120/208, 120/240 volt outlet per applicable cord in shaded area shown. Refer
to installation instructions for proper positioning of outlet. This is also the recommended gas line location.
2. Dimension K (figure 3, page 3) is from the wall to the side edge of the oven door. It does not include the curvature
of the glass or the depth of the handle.
3. Dimension L (figure 3, page 3) is with the leveler legs adjusted all the way in. This may vary slightly upon leveling
leg adjustment.
4. Do not use grout, epoxy, etc., to install this unit. Installation must allow for removal of this appliance from the
installed location for purposes of servicing.
IMPORTANT: Because of continuing product improvements, Maytag reserves the right to change specifications
without notice. Dimensional specifications are provided for planning purposes only. For complete details see
installation instructions that accompany each product before selecting cabinetry, making cutouts or beginning
installation.
A – 2
FIGURE 2
16022089
©2005 Maytag Services