Samsung S1050 Service Manual page 42

Ⅲ. ADJUSTMENT
4) Full Version of Firmware
How to do the Full Version of Firmware
Depend on the camera status If the Full version of Firmware is needed, upgrade the Full Version of Firmware.
▷Camera Status : When turning on the camera, the power consumption (Checking the POWER SUPPLY) is
▷Cause
: The data of 0 address in the FLASH MEMORY of the MAIN PCB is damaged
▷Solution
: Recover the address by doing the FULL VERSION FIRMWARE shown below.
▷Additions
: After completing the upgrading of the FULL VERSION FIRMWARE, do the LENS
▷Information
:
- The Full Version of Firmware delets all the files saved in the camera and newly install the firmware.
- After Full Version of Firmware, all the adjusted data is deleted that the back up and upload of data is needed.
- The previous adjusted data will be saved in SD card automatically when updating Full Version of firmware and
after updating completed, upload the file
- Check the back up files CLUT0.BIN, DefectivePixel0.bin andÄDefectivePixel1.bin at the SD cardÄwhich are
previous adjusted data.
1. Insert the SD card that has the Full version of firmware.
* Back up all the datas in the Flash memory cause all the data will be erased while updating Full version of
firmware. The firmware file name must be Ä"STS3105_FULL.ELF".
200-300mA and the camera can't be operated
SHADING and CCD DEFECT CELL adjustment.
42