Table of Contents
Advertisement
To remove the SIMMs
1
Facing the top of the SIMMs, push the side
clips gently to the outside (away from the
SIMM).
2
Push over and pull out, being careful not to
damage the fingers on the top.
To install the new SIMM
1
Insert at a 45 degree angle and slowly push the SIMM to a 90
two side clips snap into place. Make sure the SIMM is fully seated.
2
Carefully reconnect the ribbon cable harness to the connector on the PC
board. Reattach the other connectors removed earlier.
3
Reinstall the right cover and top cover.
TM
VinylJet 36
Reference Guide
o
angle until the
Installing additional memory A-2
Advertisement
Table of Contents
