ASSEMBLY
OF THE SNOW
THROWER
•
Tilt the snow thrower back down to the ground.
Place the
lift handle into the lift bracket on the right
side of the snow thrower. Fasten the handle to the
bracket
two 5/16" x 1-3/4" hex bolts, 5/16"
lock
and 5/16" hex nuts. See figure 15.
LIFT HANDLE
_.
/
511 6" LOCK
WASHER
l
5/16" x 1-3/4"
HEX BOLT
LIFT BRACKET
FIGURE 15
RIGHT SIDE VIEW
NOTE:
Be sure the lift release cable's plastic covering
remains insertedd into the trigger assembly while
performing
the next step.
•
Push the lift handle down into the locked position.
Insert the
end of the cable wire into the hole in the
lift rod.
Place the threa
lift
with one h
nut and the lock washe
nuts,
them to
wire. See