Initial Setup - NewAir WCD-210BK Owner's Manual

IMPORTANT: Customers are not meant to adjust the temperature by removing the
sticker or screw at the back of the appliance. Doing so will void the warranty if
product issues are found to be caused by such adjustments.
TEMPERATURE ADJUSTMENT
To adjust the water temperature on the unit, locate the white plug on the left side of the unit. Remove the
plug to expose an area where you can use a flat tip to adjust the water temperature for both hot and cold.
This feature is meant to be used by a certified technician only. If this feature is used and issues occur with
the unit, the warranty will be voided.
Do not adjust the temperature by manipulating the screw at the back of the appliance because the unit may
not cool or may not stop cooling. This can form ice and damage the unit.

INITIAL SETUP

IMPORTANT: Do not plug in the unit before installing a water bottle. Operating the
unit with an empty hot water tank can cause physical damage to the water
dispenser.
WATER BOTTLE INSTALLATION
This unit is designed to work with 2-gallon, 3-gallon or 5-gallon bottles of drinking water. To install the water
bottle follow these instructions:
1. Remove the label from the cap of the bottle. Do not remove the plastic cap.
2. Use a clean cloth to wipe the cap and neck of the bottle.
3. Lift and invert the bottle, and insert the bottle neck into the water guard.
4. Wait for internal tank to fill. The internal tank is 1-gallon and should take about 30 seconds to fill (wait
until bubble stop rising from the bottom of the bottle).
5. Turn on the Red (hot) tap until water flows from it.
6. Plug the unit into an appropriate wall outlet.
7. Turn on the switches on the rear of the unit one at a time (do not turn on the switches at the same time).
The heating lamp and the cooling lamp will light up.
INITIAL CLEANING
This unit has been cleaned and sanitized prior to shipping, however to remove dust accumulated during
shipping, we recommend rinsing the water lines and tank upon initial operation:
1. Allow the unit to run with the water bottle in place for 30 minutes.
2. After 30 minutes, turn the unit off, unplug it, and remove the water bottle.
6
http://www.NewAir.com