Cleaning & Maintenance - NewAir WCD-210BK Owner's Manual

3. Run all taps until they are empty, then open the drain plug on the back of the unit and drain remaining
water from the dispenser into a bucket or other container.
4. Once the unit has been completely flushed, you can replace the bottle and restart the unit according to
the instructions above.
CAUTION: To avoid burns, avoid direct contact with the hot water. Never allow children to
dispense hot water without supervision.
CLEANING & MAINTENANCE
CLEANING THE HOUSING
 Use a soft, damp cloth to wipe the body clean. Clean the drip tray and storage cabinet as needed.
 Remove dust from the condenser coils on the back of the unit to improve efficiency.
 Never use strong chemicals, gasoline, detergents, chemically-treated cloths, or any other cleaning
solutions to clean the water dispenser, as these can all potentially damage the unit.
CLEANING THE WATER TANKS
To periodically clean the water tanks, follow the procedure described for "Initial Cleaning" on page 6 of this
manual. Hard water may cause mineral deposits to build up on the interior of the hot water tank, resulting in a
decrease in heating capacity. To remove deposits, fill the hot water tank with an aqueous solution of 2% citric
acid and leave for two hours. Flush system completely as described above. If the problem persists, contact
your dealer or Customer Service for assistance.
 If power supply cord on this device is damaged, it must be replaced with a special power supply cord
that is obtainable at the Service Center of our company.
 If the water dispenser will go unused for more than a few days, it is recommended that you unplug the
unit, remove the water bottle, and drain the unit completely.
7
A Name You Can Trust