Initial Setup - NewAir WCD-100W Owner's Manual

INITIAL SETUP

IMPORTANT: Do not plug in the unit before installing a water bottle. Operating the
unit with an empty hot water tank can cause physical damage to the water
dispenser.
WATER BOTTLE INSTALLATION
This unit is designed to work with 2-gallon, 3-gallon or 5-gallon bottles of drinking water. To install the water
bottle:
1. Remove the label from the cap of the bottle. Do not remove the plastic cap.
2. Use a clean cloth to wipe the cap and neck of the bottle.
3. Lift and invert the bottle, and insert the bottle neck into the water guard.
4. Turn on the Red (hot) tap until water flows from it.
5. Plug the unit into an appropriate wall outlet.
6. Turn on the switches on the rear of the unit one at a time (do not turn on the switches at the same time).
The heating lamp and the cooling lamp will light up.
INITIAL CLEANING
This unit has been cleaned and sanitized prior to shipping, however to remove dust accumulated during
shipping, we recommend rinsing the water lines and tank upon initial operation:
1. Allow the unit to run with the water bottle in place for 30 minutes.
2. After 30 minutes, turn the unit off, unplug it, and remove the water bottle.
3. Run all taps until they are empty, then open the drain plug on the back of the unit and drain remaining
water from the dispenser into a bucket or other container.
4. Once the unit has been completely flushed, you can replace the bottle and restart the unit according to
the instructions above.
CAUTION: To avoid burns, avoid direct contact with the hot water. Never allow children to
dispense hot water without supervision.
6
http://www.NewAir.com