Assembly - Pro-Form Stride Select PFEL09807.0 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: Some small parts may have
been pre-assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M8 Split M10 Spring Wave Washer Large Wave
Washer (97)–10 Washer (99)–4 (80)–2 Washer (89)–2
M10 Washer M8 x 22mm M8 Locknut
(95)–4 Washer (31)–2 (94)–2
M4 x 16mm M4 x 25mm Screw M8 x 12mm Patch M8 x 19mm Patch
Screw (78)–4 (114)–2 Screw (84)–6 Screw (86)–6
M8 x 40mm Patch M8 x 58mm Shoulder M10 x 20mm Patch
Screw (90)–6 Bolt (104)–2 Screw (68)–4
M10 x 80mm Patch Screw (93)–4
5