Hi-Power Mode; Filter Indicator; Cord Heater Control - Toshiba RAS-15EKV-UL Service Manual

Item
18. Hi-POWER
([Hi-POWER] button on the remote controller
Mode
is pressed)
When [Hi-POWER] button is pressed while the indoor
unit is in Auto, Cooling or Heating operation, Hi-
POWER mark is indicated on the display of the remote
controller and the unit operates as follows.
1. Automatic operation
2. Cooling operation
3. Heating operation
4. The Hi-POWER mode can not be set in Dry
When the elapsed time reaches 1000 hours after
19. FILTER
conditioner operation, the FILTER indicator lights.
Indicator
After cleaning the filters, turn off the FILTER indicator.
How to Turn Off FILTER Indicator
Press [RESET] button on the indoor unit.
NOTE :
If [RESET] button is pushed while the FILTER indicator
is not lit, the indoor unit will start the automatic
operation.
20. Cord heater <Base plate cord heater control>
control
(V2 Series only)
When TO sensor is defective, turn off normal heater
output. When COOL thermostat is ON, turn off the
heater output.
Operation flow and applicable data, etc.
• The indoor unit operates in according to the
current operation.
• The preset temperature drops 2.0°F (1ºC)
(The value of the preset temperature on the
remote controller does not change.)
The indoor unit's fan speed level increase 1 tap
• The preset temperature increases 3.5°F (2ºC)
(The value of the preset temperature on the
remote controller does not change.)
The indoor unit's fan speed level increase 1 tap
operation
TO temp.
4˚C
0˚C
∗ The Hi-POWER operation will be cancelled
when press [Hi-POWER] button again.
1. Purpose
Heater output
2. Operation
OFF
ON
(Equivalent to 75W)
45
− −
FILE NO. SVM-13070
Description
Base plate freeze prevention of the
outdoor unit
As shown in the left figure, the base
plate freeze preventive heater is
controlled by temperature of the
outside temp. sensor (TO).
.
.