Placing The Motorcycle On The Centre Stand - APRILIA ETV mille Workshop Manual

GENERAL INFORMATION
1.9.2 PLACING THE MOTORCYCLE ON THE CENTRE
STAND
Read 0.5.1 (GENERAL
INFORMATION) carefully.
Part no. 8140176 (complete stand).
!
Place the motorcycle on the front wheel stand
see 1.9.1 (PLACING THE MOTORCYCLE ON THE
FRONT WHEEL STAND).
!"
Hold the nut (1) steady on the inside.
!"
Release and remove the rear upper right-hand
engine mounting bolt (2).
Torque wrench setting for nut (1) / bolt (2):
50 Nm (5.0 kgm).
NOTE
The bolt (2) on the left-hand side is longer.
!"
Collect the nut (1).
!
Slide the upper right-hand mounting boss (3) into the
upper hole on the right-hand side.
!
Fit the stud bolt (4) into the upper hole on the left-hand
side and screw it fully into the mounting boss (3).
!
Screw the upper left-hand mounting boss (5) fully onto
stud bolt (4) and tighten.
!"
Hold the nut (6) on the inside steady.
!"
Release and remove the rear lower engine mounting
bolt (7).
Torque wrench setting for nut (6) / bolt (7):
50 Nm (5.0 kgm).
NOTE
The bolt (7) on the right-hand side is longer.
!
Slide the lower right-hand mounting boss (8) into the
lower hole on the right-hand side.
!
Fit the stud bolt (9) into the lower hole on the left-hand
side and screw it fully into the mounting boss (8).
!
Screw the lower left-hand mounting boss (10) fully onto
stud bolt (9) and tighten.
!
Fit the bracket (11) onto the mounting bosses (3-8).
The longer portion of the bracket base must be facing
forward.
!
Snug the two washers (12 - 13) and nuts (14 - 15)
finger-tight.
!
Tighten both nuts (14 - 15).
!
Fit the bracket (16) onto the mounting bosses (5-10)
with the longer portion of the base facing forward.
!
Snug the two washers (17 - 18) and nuts (19 - 20)
finger-tight.
!
Tighten both nuts (19 - 20).
!
Remove the wheel stands.
1 - 18 -
00
PRECAUTIONS AND
,
2
1
5
4
3
12
14
11
9
8
13
15
11
ETV mille
7
6
19
17
16
20
10
18
16
Release 00/2004 - 04