Table of Contents
Advertisement
NVE-M300P Navigation Module Owner's Manual
7 Navigating with Alpine Navigation Software
You can set up your route in Alpine Navigation Software in several ways:
•
if you need a simple route (a route with only one destination, without any intermediate
waypoints), you can select the destination and start navigating to it right away
•
you can plan a multi-point route
•
you can also plan a route independently of your current GPS position or even without GPS
reception
7.1 Selecting the destination of a route
Alpine Navigation Software offers you several ways of choosing your destination and waypoints
(intermediate destinations):
•
Use the selected location on the map (the Cursor) (page 28).
•
Enter a full address or a part of an address, for example a street name without a house number
or the names of two intersecting streets (page 29).
•
Enter an address with postal code (page 34). This way you do not need to select the name of
the settlement and the search for street names might be faster as well.
•
Use a coordinate (page 37)
•
Use a saved location:
•
a Favourite (page 35)
•
a POI (page 35)
•
the History of previously set destinations and waypoints (page 36)
Tip!
If you are going to use a route later, save it before you start navigating. Tap the
following buttons:
7.1.1 Selecting the Cursor as the destination
1.
Locate your destination on the map: move and scale the map as needed (page 16).
2.
Tap the location that you want to select as your destination. The Cursor (
3.
Tap
4.
The map appears with the selected point in the middle. Tap
then automatically calculated, and you can start navigating.
Tip!
If you know that you will use a destination later, instead of tapping
selected location as a POI or put it on the list of your Favourites first. The map returns
28
,
to open the Cursor menu.
, tap
,
.
. The Cursor menu appears, save the
) appears.
. The route is
Advertisement
Chapters
Table of Contents
