Mazda MAZDA5 2006 Installation Instructions Manual page 6

4
REMOTE START CONTROL MODULE PREPARATION
1. Insert the supplied fuses into the remote start control module as shown in below (FIGURE Z).
the fuses fit tight so use a tool handle to seat them in place if necessary.
2. Install DNA card into the remote start control module as shown below. (FIGURE AA)
NOTE: Use care to assure that both rows of the multipin connectors are aligned and seated properly.
3. Plug the supplied wire harness 10-way and 24-way connectors into the remote start control mod-
ule (FIGURE BB). Make sure the harnesses are seated completely. NOTE: The connectors will
only plug into the remote start control module one way.
4. Plug the supplied immobilizer interface 4-way connector into the remote start control module.
(FIGURE BB)
NOTE: TAPE OFF THE WHITE WIRE (IF EQUIPPED) COMING FROM THE 4-WAY
CONNECTOR (THIS WIRE IS NOT USED ON THIS SYSTEM).
NOTE: FOR 2008 AND NEWER REFER TO
SUPPLEMENT AT THE END OF THIS FILE
DOME LIGHT
TRUNK RELEASE
HVAC 1
HVAC 2
FIGURE Z
5
REMOTE ENGINE START MODULE AND IMMOBILIZER INTERFACE MOUNTING
REMOTE ENGINE START MODULE MOUNTING
1. Route the dipole antenna cable (previously installed in step 2)
and plug into the 2-pin connector on the bottom of the remote
start control module.
2. Locate the large dashboard support bracket to the left of the
steering column.
3. Using (3) supplied long tie wraps secure the remote start con-
trol module to the left side of the dashboard support bracket.
Make sure that the remote start control module is not mounted
to far down on the bracket, this will eliminate problems with
dashboard reassembly. (FIGURE CC)
IMMOBILIZER INTERFACE MODULE MOUNTING
1. Locate the Large dashboard support bracket to the left of the
steering column.
2. Using (1) supplied long tie wrap, secure the immobilizer inter-
face to the dashboard bracket. (FIGURE DD)
PK LIGHTS
DOOR LOCKS
MAIN B+
IGNITION
FIGURE AA
6
FIGURE BB
FIGURE CC
Tie Wraps
FIGURE DD
Tie Wraps
1030658 Rev.A 09/05