Mazda MAZDA5 2006 Installation Instructions Manual page 15

18
HOOD SAFETY SWITCH ADJUSTMENT
The hood safety will need to be adjusted to shutdown the vehicle when the hood is raised to the full upright position
1. Raise and prop the vehicle's hood.
2. The hood switch cylinder should be bend away from the hood to approximately 15 degrees above parallel with the
ground. (FIGURE ZZ)
3. After the adjustment has been made verify that remote start system does not engage when the vehicle's hood is
open.
4. If the remote start system engages with the hood in the full upright position, the switch will need to be bent closer to
the hood.
NOTE: IT IS VERY IMPORTANT TO VERIFY THAT THE HOOD
SAFETY SWITCH PREVENTS THE REMOTE ENGINE START
SYSTEM FROM ENGAGING WHEN THE VEHICLE'S HOOD IS
IN THE FULL UPRIGHT POSITION
19
SERVICE PART NUMBER LIST
Part Number
0000-8F-H03
0000-8F-Z01
0000-8F-L06
0000-8F-H05
0000-8F-F05
0000-8F-Z02
0000-8F-Z10
PowerCode®, IT-s®, Real Panic Sound® and Progressive Find® are registered trademarks of Code Systems, Inc.
Description
Hood Safety Switch Kit
Remote Start Control Module Service Part
Mazda5 Remote Start Wire Harness Service Part
Mazda5 Immobilizer Interface Service Part
Mazda5 DNA Card Software Service Part
Mazda5 1-Button Remote Start Transmitter Service Part
Dipole Antenna
FIGURE ZZ
15
1030658 Rev.A 09/05