Mazda MAZDA5 2006 Installation Instructions Manual page 10

9
WIRE HARNESS CONNECTIONS- STEERING COLUMN
MULTIFUNCTION SWITCH CONNECTOR (C-459 CONNECTOR)
1. Locate the 12-way WHITE multifunction switch connector on the left
side of the steering column (plugged into the turn signal assembly).
2. Remove the 12-way connector from the multifunction switch.
3. Plug the 12-way female remote start harness connector into the
multifunction switch. (FIGURE LL)
4. Plug the previously removed vehicle 12-way female connector into
the remote start harness 12-way male connector. (FIGURE LL)
5. Using (2) supplied tie wraps, secure the 12 way multifunction switch
harness to the factory wiring on the left side of the steering column.
(FIGURE MM)
HORN CONNECTION (CLOCKSPRING C-437 CONNECTOR)
1. Locate the 12-way YELLOW C-437 clockspring connector at
the base of the steering wheell.
2. Using a razor knife carefully cut back 1"-2" of the plastic shield-
ing to expose the wiring (BE EXTREMELY CAREFUL NOT TO
DAMAGE ANY OF THE WIRES).
3. Using the (1) supplied IDC wire tap, connect the wire listed be-
low and crimp the IDC wire tap in place using pliers, assure
that a complete and secure connection is made. Refer to FIG-
URE NN & OO for proper connector and pin location.
VEHICLE'S HORN WIRE
VIOLET/WHITE
4. Using (2) supplied tie wraps secure the remote start wiring and
immobilizer interface wiring to the vehicle's factory ignition wir-
ing. (FIGURE PP)
NOTE: IT IS EXTREMELY IMPORTANT THAT THE WIR-
ING IS SECURED IN A MANNER THAT WILL ALLOW
THE TILT/TELESCOPING STEERING WHEEL TO MOVE
FREELY AND STILL ALLOW FOR REASSEMBLY OF THE
STEERING COLUMN SHROUD. CHECK FUNCTIONAL-
ITY OF THE TILT TELESCOPING STEERING WHEEL
PRIOR TO REASSEMBLY.
REMOTE START HARNESS WIRE
VIOLET/WHITE
10
FIGURE LL
FIGURE MM
VIEW FROM WIRE END
VIOLET/WHITE PIN
LOCATION INDICATED BY X
FIGURE NN
FIGURE OO
FIGURE PP
1030658 Rev.A 09/05