Instructions For Normal Operation; Load The Machine; Start A Formula; After A Completed Formula (Normal) - Milnor MWR09E5 Series General Operating And Troubleshooting

BICEUO01 (Published) Book specs- Dates: 20060823 / 20060823 / 20060823 Lang: ENG01 Applic: CEP
3.3. E-P OneTouch

Instructions for Normal Operation

3.3.1.

Load the Machine

3.3.1.1.
1. If the loading door is closed and latched, hold the Door Unlock button (
while turning the door latch handle with the other hand. If the door does not unlock, verify
that the machine is connected to power and that the wall disconnect is functioning properly.
The machine must have power available to unlock the door.
2. When the door opens, load the machine according to plant guidelines and Section 3.1.
"Determining Load Size".
3. Close the door firmly.

Start a Formula

3.3.1.2.

After a Completed Formula (Normal)

3.3.1.2.
1.
press the button that matches the formula you want to run. The selected formula will start
immediately if the door is closed. The Formula Running light (
immediately, and the machine fills with water. Once the door is locked, the operator must end the
formula early (see Section 3.3.2) or wait for the formula to finish before opening the door.

After Opening the Door during a Formula

3.3.1.2.
2.
opening the door, you must press the Terminate button (
again. The Terminate button also clears any internal machine error that might have caused the
formula to end early.

Unload the Machine

3.3.1.3.
Hold the Door Unlock button (
other hand.

How to End a Formula Early

3.3.2.
You can end any running formula by pressing the Terminate button (
safety delay keeps the door locked for 75 seconds. When the In Progress light goes off, hold the
Door Unlock button (
hand.
To resume operation, restart the formula from the beginning by pressing the desired formula
button.
®
Operation
—If the previous formula finished normally, simply
—When the formula ends, the Formula Running light (
) to unlock the door while turning the door latch handle with the
'
) to unlock the door while turning the door latch handle with the other
'
— End of BICEUO01 —
) illuminates and the door locks
\
—If you ended the previous formula early by
) before you can start the machine
z
) on the control panel. A
z
PELLERIN MILNOR CORPORATION
Chapter 3. Operating
) to unlock the door
'
) goes out.
\