Table of Contents
Advertisement
2. Adjustment menu
2.1. Remote controllable items
Mode
Boot mode
Stand-by mode
Start-up process
Shut down process invalid
Steady state
2.2. Projector information display
DISPLAY
DISPLAY
DISPLAY
DISPLAY
button
LAMP TIMER
LAMP A
LAMP B
INPUT
SYSTEM ID
NO SIGNAL
MUTE
DISPLAY
DISPLAY
FUNC
FUNC
DISPLAY
DISPLAY
FUNC
FUNC
+
F/W VER
H/W VER
SET TIMER
LAMP A TIMER
LAMP B TIMER
BAUD
F/W
MENU SW
2.3. Video memory select
MEM LIST
MEM LIST
MEM LIST
MEM LIST
MEM LIST button (at non menu display)
MEMORY SELECT 1
2.4. Picture mute
Picture mute/ cancel
MUTE
MUTE
MUTE
MUTE
VS-SH10U Set-up and Installation Manual
Controllable item
invalid
Turning on
Turning off
Turning off
Projector information display
Video memory select
Picture mute
Test pattern display
RGB color mute
Remote ID setting
Picture adjustment
Service adjustment
Factory adjustment
99999H
BUSY NEW
STANDBY NEW
ANALOG/DIGITAL
1 – 32
(ANALOG)
button
H.18
1.1
999999H
999999H
999999H
19200/9600
WRITABLE/
NOT WRITABLE
ON
State that firmware is not written.
Remote control is not available.
Power-off state. Only turning on
is available by remote control.
Remote control is not available
for 30 seconds after shut down.
Lamp operating time
Lamp A status
Lamp B status
Input select
Remote ID setting. Red indications when
remote ID is disable.
Indicating when no signal inputs.
Indicating on picture mute.
Firmware version
Hardware version
Projector operating time
Lamp A operating time
Lamp B operating time
Baud rate selection
Firmware protection
To be invisible certain items in factory menu.
Select 01 – 16 in number buttons during 5-
second display.
15
Memo
Advertisement
Table of Contents
