Table of Contents
Advertisement
01GB00ICS-X7.book Page 65 Friday, October 12, 2012 9:24 PM
Installation
Caution
Do not block the unit's fan or heat sink, thus preventing
air circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
Air ventilation hole
Rear of the Unit
Caution concerning the installation location
1
Angle of installation
Install at an angle between horizontal and 30°. Note
that installing at an angle outside of this range will
result in a loss of performance and possibly
damage.
0 -30°
2
Mounting the Microphone.
For safe use, make sure of the following:
• location is stable and firm.
• driver's view and operations are not obstructed.
• microphone is located where the driver's voice can be easily
picked up (on the sun visor, etc.).
When you speak into the microphone, you should not have
to change your driving posture. This may cause a
distraction, taking your attention away from safely driving
your vehicle. Carefully consider direction and distance while
mounting the microphone. Confirm that the driver's voice
can be easily picked up at the selected location.
Cable clamp
(Sold separately)
01GB07ICS-X7.fm
Heat sink
Microphone
3
Remove the mounting sleeve from the main unit (see
"Removal" on page 65).
Slide the unit into the mounting sleeve and secure it.
Mounting Sleeve
Dashboard
(Included)
Pressure
1
Plates
*
Face Plate*
1
*
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
*
The supplied face plate may be mounted.
4
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*1) already
attached to the vehicle's chassis. Connect all the
leads of the ICS-X7 according to details described in
the CONNECTION section.
Hex Nut (M5)
*
Metal
Mounting
Strap
1
*
Ground Lead
Chassis
• For the screw marked "*2," use an appropriate screw for the chosen
mounting location.
5
Slide the ICS-X7 into the dashboard until it clicks.
This ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
This unit
2. Pull the unit out, keeping it unlocked as you do so.
ALPINE ICS-X7 68-21057Z38-A (EN)
This unit
2
(Included)
Screw
2
Bolt Stud
This unit
Bracket keys
(Included)
65
-EN
Advertisement
Table of Contents
