Dump; Using The Object Utilities From The Editor - Kurzweil PC3 Getting Started Manual

Dump

This utility is for dumping selected objects over MIDI. If any of the selected objects have
dependents that were not selected, you will be asked the question "Dump dependent objects?"
Press OK to initiate a MIDI System Exclusive dump of the selected set of objects, one by one out
the MIDI Out port of the PC3. Dumping everything can generate massive dumps, so you should
know the limits of the device you're dumping to.You can cancel the dump at any time with the
Cancel soft button.

Using the Object Utilities from the Editor

You can get to the object utilities while editing any object. For example, you could use the object
utilities to make copies of objects. Press the Object soft button from any Save/Replace dialog in
the editor to access the object utilities. You can get to this Save/Replace dialog when editing an
object by either exiting after you have modified the object, or pressing the Save soft button.
If you try to use the Copy utility to copy the exact object you are in the process of editing, you
will make a copy of the edited version. When using the Object Utilities from within the editor,
you must be careful not to delete any of the objects you are currently editing. This could have
unpredictable results.
Preliminary - Subject to Change
Master Mode
Object Utilities
11-9