Kodak EasyShare CX4310 User Manual page 72

Camera
Problem
Camera freezes up
when a card is
inserted or
removed.
Picture is too light. The flash is not needed. Change to Auto flash
Stored pictures are
damaged.
Pictures remaining
number does not
decrease after
taking a picture.
Picture orientation
is not accurate.
64
Chapter 9
Cause
Camera detects an error
when the card was
inserted or removed.
The subject was too
close when the flash was
used.
Lighting condition is too
bright.
The card was removed
when the ready light was
blinking.
Picture does not take up
sufficient space to
decrease the picture
remaining number.
The camera sensed that
it was rotated or tilted
while the picture was
taken.
Solution
Turn the camera off, then
back on. Make sure the
camera is turned off before
inserting or removing a
card.
(page 18).
Move so there is at least 1.6
ft (0.5 m) between the
camera and the subject.
Decrease exposure
compensation (page
Make sure the ready light is
not blinking, then turn off
the camera before removing
the card.
The camera is operating
normally. Continue taking
pictures.
Set the Orientation Sensor
(page 26). Turn off the
Orientation Sensor when
your subject is above or
below you (such as in the
sky or on the floor).
23).