Table of Contents
Advertisement
Network Camera User's Manual
Note:
Using a power supply with a different voltage than the one included with the Network
Camera will cause damage and void the warranty for this product.
Connections
Hardware description
1. DC Power Jack
The DC power input jack is located on the rear of Network Camera's. The input power is
12VDC. Note that supply the power to the Network Camera with standard power adapter
included in package. Otherwise, the improper power adapter may damage the unit and
result in danger.
2. LAN Socket
Beside the DC power Jack, the LAN socket is an RJ-45 connector for connections to
10Base-T or 100Base-TX Fast Ethernet cabling. Please use Category 5 ―straight
through‖ cable to connect the Network Camera to an Ethernet network switch or hub.
3. Antenna (Wireless model only)
4. Microphone
The Network Camera's has built-in an internal microphone. This microphone is also
hidden in the pinhole located on the head of camera.
5. Front LEDs
Red LED indicates power, red LED will turn on always after plug-in power.
Green LED indicates networking, green LED will blink every second after getting IP
address.
Upon powering up, two of front LEDs will become lighted then the camera will do
self-rotation. During the self-rotation, red LED will be on and the network camera is
standby for getting IP address.
6. Factory Default Reset
This button is hidden in the pinhole under then Network Camera's bottom. Please refer
to the Appendix A in this manual for more information.
7.SD Card slot and USB socket
The built-in SD/SDHC card slot offers a convenient and portable storage
(snapshots and video clips) option to prevent data loss in case of network
disconnection.
8.Microphone in and Audio out
The Network Camera supports two way audio communication so that operators can
transmit and receive audio simultaneously. By using the Network Camera's built-in or
external microphone and an external speaker, you can communicate with people around
the Network Camera.
5/62
Advertisement
Table of Contents
